Search found 9 matches

by digi303
21 Apr 2019, 10:31
Forum: General questions
Topic: leaving OFF-Mode with IFTTT
Replies: 0
Views: 146

leaving OFF-Mode with IFTTT

hi folks, I have a problem with the thermostat. I use IFTTT and the thermostat to switch to the OFF mode when a certain outdoor temperature is reached. This works great. Unfortunately, I can not turn the thermostat back on when it falls below a certain temperature. The outside temperature is measure...
by digi303
15 Feb 2019, 18:03
Forum: General questions
Topic: Open Window detection
Replies: 82
Views: 5987

Re: Open Window detection

OK, the relais says firmware 203 but the valves are still on v73...

Can I manually trigger the update of the valves?
by digi303
15 Feb 2019, 15:11
Forum: General questions
Topic: Open Window detection
Replies: 82
Views: 5987

Re: Open Window detection

I must try this.

Relais: 70:EE:50:0B:D7:28

5 valves

Thank you
by digi303
17 Dec 2018, 10:21
Forum: General questions
Topic: Open Window detection
Replies: 82
Views: 5987

Re: Open Window detection

Hi fra_c,

the window open detection is not yet implemented - but is announced over a year.

But the temperature measurements stucks when a window is opened. This overheats the room and wastes a lot of energy.
by digi303
10 Dec 2018, 12:54
Forum: My Weather Station data
Topic: CO2 Data not correct
Replies: 1
Views: 296

CO2 Data not correct

Since the server crash on November 22, 2018, my CO2 data is no longer correct. Actually, the modules should calibrate automatically. But there's something wrong with these values. SZ1.jpg WZ1.jpg I then started a manual calibration and put the modules out there - it has gotten a bit better, but stil...
by digi303
10 Dec 2018, 11:58
Forum: General questions
Topic: Smart valves installation in old radiator
Replies: 2
Views: 144

Re: Smart valves installation in old radiator

For me, this looks like a return temperature limiter. Do you have a Surface heating in the ground?

If so, you can not use Netatmo thermostatic valves there.
by digi303
10 Dec 2018, 10:03
Forum: General questions
Topic: Open Window detection
Replies: 82
Views: 5987

Re: Open Window detection

I do not know what you have. The window open detection works perfectly. After a temperature fall, the measured temperature simply stucks. This ensures that it is definitely not too cold in the room. :(
by digi303
10 Dec 2018, 09:44
Forum: General questions
Topic: Valves reports bad battery while its totally full
Replies: 29
Views: 1578

Re: Valves reports bad battery while its totally full

I have the same issue. Unfortunately the valves report without warning "empty batteries" which causes the heater to run at 100%. This behavior waste a lot of energy. However a reset helps to stop the empty batterie of beeing empty.

Thank you Netatmo...

Go to advanced search