Netatmo Forum

Luca,
what FW are your valves and relay on ? AFAIK the working versions are not publicly released yet.

-Markus

Not 100% sure. I opened the bathroom window fully, to get rid of humidity. It was only 3 degrees outside that day. I kind of forgot to close it and it was open for about 15-20 Minutes. The valve sits on the bottom of the radiator, ca 20-35cm above the floor. So the room and valve got really cold. No...

Hi,
the release 161/50 works really well. No side effects and my problematic valve (bathroom) closes. During the past almost 3 weeks I had only one hick-up, where it did not close. I reported that to Netatmo.

So if you have problems with your valves, try to get upgraded to 161/50.

Thanks,
-Markus

Hi,
I also have no Thermostat, just relais and valves.

In the past weeks I got this message only on one valve. Now this seems to come up on more valves (it just happened on all) and more frequently.

Anybody else experience the same ?


Thanks,
-Markus

Hi,
send Brieuc a private message and/or open a ticket. If they need more testers, you will probably get the beta-FW. On the other hand: if the FW runs well, I think Netatmo will release it soon to everybody.

-Markus

I noticed the two ("hot" and "cold") settings in the temp-override section. I struggled a bit, because I found the naming not so intuitive.

Nevertheless since I adjusted these for all may valves, the accuracy has improved dramatically.

-Markus

Hi,
Netatmo seems to have found and fixed the issue. I was assigned a beta FW which - since yesterday - seems to run fine. I promised to further look into this and provide feedback but so far it is looking really good.

-Markus

Any news ? Are you guys at Netatmo still alive/in business and work on a solution ? I have provided lots of info here and have an open case with customer support, but the radiator still happily heats the bathroom where it tells it is not. This is a waste of energy. Screenshot-2017-12-18 Netatmo.png ...

Even worse in the bathroom. Screenshot-2017-12-14 Netatmo(2).png When the boiler came up again around 11, the valve measured about 19 degrees. It keeps this through the day, demanding "full power" heating all the time. The temperature was about 21 around 15.00 and just reached 22 degrees at 22.30. N...

Hi, tonight my boiler (not regulated by Thermostat) got into an error condition so rooms where quite chilly when I got up late this morning. I then quickly heated via wood-oven before fixing the boiler. Screenshot-2017-12-14 Netatmo(1).png So one can see that temp - as measured by valve - got stuck ...