Search found 56 matches
- 31 Oct 2018, 19:36
- Forum: General questions
- Topic: Delay in switching off the boiler
- Replies: 2
- Views: 816
Re: Delay in switching off the boiler
Actually it would make sense to switch boiler sooner than valve as (for example) my boiler is keeping waterflow for a while after boil signal is off.
- 31 Oct 2018, 19:33
- Forum: General questions
- Topic: Boiler switched on with all valves closed
- Replies: 7
- Views: 1413
Re: Boiler switched on with all valves closed
Guess that is different issue then
- 30 Oct 2018, 19:07
- Forum: General questions
- Topic: Valve not reachable
- Replies: 6
- Views: 2185
Re: Valve not reachable
All the valves and thermostats "talks" directly to relay, they arent really able to create mesh network. Maybe 2 relays can fix the issue?
- 30 Oct 2018, 17:08
- Forum: General questions
- Topic: Boiler switched on with all valves closed
- Replies: 7
- Views: 1413
Re: Boiler switched on with all valves closed
That depends - it solves boiler heating or valve closing?
- 30 Oct 2018, 17:06
- Forum: General questions
- Topic: Valve always closed
- Replies: 9
- Views: 1907
Re: Valve always closed
It's not this as i bought smarties in september.
The behavior you are experiencing is exactly what i experienced. I guess that the valve is sticking and calibration thinks it can open just a little bit. Replacing mechanical valve worked out well
The behavior you are experiencing is exactly what i experienced. I guess that the valve is sticking and calibration thinks it can open just a little bit. Replacing mechanical valve worked out well
- 29 Oct 2018, 19:04
- Forum: General questions
- Topic: Boiler switched on with all valves closed
- Replies: 7
- Views: 1413
Re: Boiler switched on with all valves closed
I did experienced similiar issue. It was mechanical / calibration issue. Netatmo promised firmware with calibration fix within few weeks, but i fixed it with replacing mechanical valve on the radiator.
https://forum.netatmo.com/viewtopic.php?f=73&t=14678
https://forum.netatmo.com/viewtopic.php?f=73&t=14678
- 27 Oct 2018, 21:40
- Forum: General questions
- Topic: Frosted display - hard to see temp
- Replies: 3
- Views: 950
Re: Frosted display - hard to see temp
From my POV the display is defective. Ask for replacement at customer service.
- 25 Oct 2018, 17:12
- Forum: General questions
- Topic: Boiler overheating
- Replies: 3
- Views: 777
Re: Boiler overheating
I just contacted support. They seem to respond within a day so far .. let's see
- 25 Oct 2018, 15:05
- Forum: General questions
- Topic: Boiler overheating
- Replies: 3
- Views: 777
Re: Boiler overheating
I can confirm this behavior. If thermostat and valve are in same room, then valve keeps closing at setpoint while thermostat still requests heating.
Workaround : Bypass thermostat by creating virtual room with lower temperature setpoint.
Will contact support about this issue
Workaround : Bypass thermostat by creating virtual room with lower temperature setpoint.
Will contact support about this issue
- 24 Oct 2018, 06:13
- Forum: General questions
- Topic: Valve always closed
- Replies: 9
- Views: 1907
Re: Valve always closed
Exactly. I needed to act fast and luckily because one of the valves were leaking, i figured out changing them fixes the issue