Hello,
on my smartphone I receive notifications "Neue on Demand Messung"every minute(!) .
How come? And is there a possibility to stopp that behaviour?
It' s verry annoying.
rem.: auto kalibration is deaktivated
firmware main module 124
Modules installed: Wind gauge, rain, extra indoor module
Access for netatmo allowed.
Thank you for an answer;
Kind regards
notifications "Neue on Demand Messung" every minute
Re: notifications "Neue on Demand Messung" every minute
Hi
Same issue here. Since yesterday i recieve these messages all the time and i have a data point each minute in the graph.
I tried unplugging/ restarting the main station but it didn't help
Firmware ist 135...
Same issue here. Since yesterday i recieve these messages all the time and i have a data point each minute in the graph.
I tried unplugging/ restarting the main station but it didn't help
Firmware ist 135...
Re: notifications "Neue on Demand Messung" every minute
Hi
I've the same issue here since last night. Firmware is 135, too.
I've also observed that the station turns on the green light every minute. I don't know why.
Restarting does not help.
Does anyone know the reason?
Or better, what is the solution?
I've the same issue here since last night. Firmware is 135, too.
I've also observed that the station turns on the green light every minute. I don't know why.
Restarting does not help.
Does anyone know the reason?
Or better, what is the solution?
Re: notifications "Neue on Demand Messung" every minute
hi,
after some research(watched the log files of my Wlan router...) it looks like the quality of the original powersupply isn´t very good --> it starts dying and shuts down every few seconds under load.
because of this the station shuts down as well. After a few seconds the powersupply starts up again and with it the station starts up(green light goes on) shortly after "booting" the station collects one temperatur reading.--#>data point every minute.
next thing is the shuting down of the power agian....
i´m using a old mobile charger now and the problem is solved. But it looks like that the dying powersupply has done some damage to the station (over voltage or whatever) so that the "button" on top isn´t working anymore...
i like the concept very much but it´s very sad that there is absolutly no support for this thing. Would be realy great if there was a "easy" way do get to the data from it for own developments...
after some research(watched the log files of my Wlan router...) it looks like the quality of the original powersupply isn´t very good --> it starts dying and shuts down every few seconds under load.
because of this the station shuts down as well. After a few seconds the powersupply starts up again and with it the station starts up(green light goes on) shortly after "booting" the station collects one temperatur reading.--#>data point every minute.
next thing is the shuting down of the power agian....
i´m using a old mobile charger now and the problem is solved. But it looks like that the dying powersupply has done some damage to the station (over voltage or whatever) so that the "button" on top isn´t working anymore...
i like the concept very much but it´s very sad that there is absolutly no support for this thing. Would be realy great if there was a "easy" way do get to the data from it for own developments...
Re: notifications "Neue on Demand Messung" every minute
The same solution worked for me.
I've exchanged the power supply and everything is fine now.
Even the button on the top still works.
I fully agree, it is a shame that there is no support.
I've exchanged the power supply and everything is fine now.
Even the button on the top still works.
I fully agree, it is a shame that there is no support.