Hi
I am trying to replace my old wireless thermostat that never worked with the netatmo version.
I have connected the netatmo to the circuit board and the white light flashes. When I press the button the relay goes white but the boiler does not switch on.
I am Pretty sure I have worked it correctly but possibly not.
I have attached images of the board and also the wiring instructions
Connecting relay to vokera vision 30c not turning on
-
- Posts: 1
- Joined: 29 Sep 2020, 13:49
Connecting relay to vokera vision 30c not turning on
- Attachments
-
- Wiring diagram
- Screenshot_20200929_124702_com.google.android.apps.docs.jpg (655.61 KiB) Viewed 474 times
-
- 16013804770611881435234245258088.jpg (2.63 MiB) Viewed 474 times
-
- 16013804617188045904061125234531.jpg (1.79 MiB) Viewed 474 times
Re: Connecting relay to vokera vision 30c not turning on
If that‘s the „M2“ terminal you connected the Relais‘ black and grey wires to then you should be good.
To rule out a defect you can bridge those terminals with a piece of wire. If your boiler doesn‘t start, the problem has to be on the boiler‘s side.
Either settings or a defect. I‘m curious since you said that your old thermostat also never worked.
To rule out a defect you can bridge those terminals with a piece of wire. If your boiler doesn‘t start, the problem has to be on the boiler‘s side.
Either settings or a defect. I‘m curious since you said that your old thermostat also never worked.
Home: Weather Station (V3 + Rain & Wind Gauge, 3 additional Indoor Modules, Shield), Valves Starter Pack + 7 Valves, Video Doorbell
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee