Hello guys,
I‘m an newbie to this kind of stuff and tried my best, without much success.
I was able to get the Relais running, and it’s connected with the Thermostat. But, the Relais is still unable to control the boiler. Obviously I connected some of the cables the wrong way.
On the pictures you can see the available cables and my first try to connect them.
Any help is very much appreciated. Thanks!
Luke
Finding the right cables
Finding the right cables
- Attachments
-
- 5FC2E687-1A7A-4AD0-A188-E1C766A50319.jpeg (2.07 MiB) Viewed 659 times
-
- 0A89BFD8-A2B2-4B4E-8E1B-E3CC9CFEB547.jpeg (2.06 MiB) Viewed 659 times
Re: Finding the right cables
Connect the Herz actuator’s blue wire to the N wires as well.
Connect the Relais‘ grey wire to the actuator’s brown wire and the Relais‘ black wire to the L wires.
Black and Grey wires only connect to each other internally, they never provide any power at any time.
Connect the Relais‘ grey wire to the actuator’s brown wire and the Relais‘ black wire to the L wires.
Black and Grey wires only connect to each other internally, they never provide any power at any time.
Home: Weather Station (V3 + Rain & Wind Gauge, 3 additional Indoor Modules, Shield), Valves Starter Pack + 7 Valves, Video Doorbell
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee