Hi, I am trying to install the netatmo thermostat in my e.l.m leblanc Groupe Bosch gas heater.
There are already 2 cables connected to L&N, whicu is the power outlet. I tried disconnecting them and connecting the ones from the thermostat - doesn't work.
Should they be all connected in the same place or in outlets 1 2 of the 1234 one?
I attach the picture of the heater and its instructions.
Thanks!!
E.l.m leblanc megalis ngla24 24-4h / thermostat installation
E.l.m leblanc megalis ngla24 24-4h / thermostat installation
- Attachments
-
- 16387929302603504914027313306142.jpg (2.4 MiB) Viewed 443 times
-
- 20211206_114621.jpg (2.89 MiB) Viewed 443 times
Re: E.l.m leblanc / thermostat installation
Add the Netatmo Relais‘ brown and blue wires to L and N.
Connect the black and grey wires to LS and LR, polarity not important.
Connect the black and grey wires to LS and LR, polarity not important.
Home: Weather Station (V3 + Rain & Wind Gauge, 3 additional Indoor Modules, Shield), Valves Starter Pack + 7 Valves, Video Doorbell
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Re: E.l.m leblanc / thermostat installation
Should I remove the exising wires that are already there?
Re: E.l.m leblanc / thermostat installation
No, as said add the new ones, don‘t replace them.
Home: Weather Station (V3 + Rain & Wind Gauge, 3 additional Indoor Modules, Shield), Valves Starter Pack + 7 Valves, Video Doorbell
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee