Hi,
Yesterday I've taken my brand new Station, after two cases of bad products, returned in warranty for both cases. So this is my brand new (third!) Station.
Now, after every installation I was expecting a low value of CO2 (around 450 ppm), as the previous models I had. But, as I can see now, CO2 values are about 800 ppm during all day.
The installation point is the same as the previous stations, room is always well ventilated, firmware updated to 178 (main module) 50 (outdoor).
I've tried:
1) Calibration (even if there's no more blinking "calibration" notification in webapp)
2) Switch off for 10 minutes and power back on
3) Change room
4) Reset a couple of times
Now I've tried to join the beta test and I've contacted Netatmo by mail...I don't know what to do more
Brand new Station - wrong CO2
-
- Posts: 161
- Joined: 15 Jun 2017, 13:54
Re: Brand new Station - wrong CO2
Hello, do not hesitate to submit a support request via our Help center, specifying your ticket number if you have already been in contact with us, and we will give you a solution as quickly as possible https://www.netatmo.com/helpcenter
Re: Brand new Station - wrong CO2
midavideltu did you get it solved? I bought an additional indoor module yesterday (just submited support request) but I have the same problem.
If i open a window i manage to get the CO2 value down to 600 but not lower. Main unit goes to ~370-400 (more correct)
If i open a window i manage to get the CO2 value down to 600 but not lower. Main unit goes to ~370-400 (more correct)