ECO or COMFORT behaviour on each valve

Tips, tricks and frequently asked questions
Post Reply
Zepilef
Posts: 7
Joined: 01 Dec 2019, 15:06

ECO or COMFORT behaviour on each valve

Post by Zepilef »

Good afternoon everyone, and happy 2020.

I am in a situation where I wish toi have some rooms (valves) to drive the boiler, in COMFORT behaviour, while other rooms (valves) to act just as heat limitation (ECO).
Is Netatmo foreseeing to implement this choice per valve, instead of having it for the whole house?

Regards,
Zepilef
svito
Posts: 8
Joined: 06 Jan 2020, 17:12

Re: ECO or COMFORT behaviour on each valve

Post by svito »

I'm also joining. This option would also help me. Great idea that should not be missing in the app.
Zepilef
Posts: 7
Joined: 01 Dec 2019, 15:06

Re: ECO or COMFORT behaviour on each valve

Post by Zepilef »

@ Brieuc_Netatmo.
Do you have a plan to look into this feature?

Thank you in advance for your feedback!
ZepileF
ftr1873
Posts: 11
Joined: 11 May 2019, 18:16

Re: ECO or COMFORT behaviour on each valve

Post by ftr1873 »

+1
Zepilef
Posts: 7
Joined: 01 Dec 2019, 15:06

Re: ECO or COMFORT behaviour on each valve

Post by Zepilef »

Hi guys,

any plan to implement such a separation? :geek:

Thank you,
ZepileF
dbarea
Posts: 10
Joined: 10 Apr 2017, 16:47

Re: ECO or COMFORT behaviour on each valve

Post by dbarea »

+10000
Newbee
Posts: 1
Joined: 30 Dec 2020, 18:07

Re: ECO or COMFORT behaviour on each valve

Post by Newbee »

The Thermostat in combination with the valves are driving me crazy. I like the idea of separating eco and comfort for each device as one option too pic from.....

In addition I would be happy if the algorithm would just work for the following setup. "Thermostat and more then one valve are in the same room" e.g. 1 Thermo, 3 valves!
Thermostat requests 21C and the valves are open until the Thermostat reaches the Temp then the valves are closed completely.
If the Temp falls below 21C the valves are opening again until the 21C is reached again.

Just my two cents...
Post Reply

Return to “General questions”