Separating Relay from power/control block

[JWD]

Before I installed the relay I was checking everything fits together and made the "mistake" of attaching the block to the back of the relay. I now want to fix the block to the wall but I need to separate the two parts - it isn't obvious how to do this and I don't want to break it - any clues of what the secret is?

[Brieuc_Netatmo]

Hello,
There is no special trick, just pull hard to separate them.

[dangze]

Hello,
There is no special trick, just pull hard to separate them.

You also have to push the small "locking button" before pulling the block ! I think this is the "trick" JWD is looking for...

[JWD]

Thanks Brieuc and Dangze, I thought I had tried that with no joy - is it the one slightly behind where the cables enter the block. It is certainly a very secure/close fit!

[dangze]

Well, I have not the relay in front of me !...

It's a small button just near the limit between the relay and the block. When you have attached the block, you certainly heard a small "click"coming from this button !