[SOLVED] Range for offset temperature settings is not enough

[stanikuz]

@Brieuc_Netatmo

I am using Smart Valves for a year and I was convinced, that maximum temperature offset for hot radiators (+/- 5 degrees) is not enough for my rooms. I need to set it to -6.3...6.5 degrees for correct working.
As I had to set only -5 degrees, the temperature in my rooms does not reach the temperature which is set by schedule (or manually): they reach 1 to 1.5 degrees below. I check this by indoor modules of my Netatmo weather station, so I can compare the histories from Netatmo Energy and Netatmo Weather ecosystems for each room. So, I found this correlation for significant period of measurements.

So, could you please kindly ask your development team to extend the lowest possible offset limit for the hot radiators instead of -5 degrees to -7.5 degrees or even below?

I'll be very grateful if this limit will be extended as soon as possible, because it causes significant inconveniences in using: I have to set artificial temperatures on 1-1.5 degrees above the necessary temperatures, but it does not work good during warm days, because these temperatures are more than I would like.

[stanikuz]

I just received v193 for relay and v73 for all my valves.
Thanks to Netatmo team for resolving the issue in this newest firmware and software update!