Hello everyone,
I have a weather station version 2 in full development. To use Apple HomeKit, I have now purchased a weather station version 3.
I know that I can have Support transfer my data. I just don't understand how I can transfer my three interior modules, the wind gauge and the rain gauge.
Will I lose all my data if I disconnect the modules at the old station? Are the data still available when connecting to the V3 station?
Thank you for replying
Eric
data transfer - Station V2 to Station V3
Re: data transfer - Station V2 to Station V3
You can write email to contact-weather@netatmo.com with you new and old module MAC. Then you can delete data from old one.
Weather Station v3 & 2x Additional Indoor Module
Rain Gauge
Wind Gauge
Thermostat with relay & Relay without relay & 9x Valve
Rain Gauge
Wind Gauge
Thermostat with relay & Relay without relay & 9x Valve
-
- Posts: 2
- Joined: 14 Nov 2019, 21:17
Re: data transfer - Station V2 to Station V3
Thanks S474N.
thanks for the quick feedback. I am now in contact with the support. I will list the old and new station in a clean table. In addition, I will still give the serial number and the assigned name of the sensors, even if they don't change.
thanks for the quick feedback. I am now in contact with the support. I will list the old and new station in a clean table. In addition, I will still give the serial number and the assigned name of the sensors, even if they don't change.