Page 1 of 1

New app (warm)temperature correction fail

Posted: 17 Dec 2017, 21:38
by max@mo
The new app/web page showed a new option about the temperature correction, Cold and Warm values, but in my setup warm value doesn't work as expected.
Whatever the value I'll put in the "Warm" section , it'll no provide any "update" on the temperature showed by the valve.
Is it just a fault in my valve/setup ?

Re: New app (warm)temperature correction fail

Posted: 17 Dec 2017, 22:50
by Thucydides
Same problem here

Re: New app (warm)temperature correction fail

Posted: 18 Dec 2017, 16:40
by Brieuc_Netatmo
Hi,
Please note that the "warm radiator" setting can take up to 24H to be taken into account.
We will add a short sentence in the description to mention that, thank you for having reported this issue.

Re: New app (warm)temperature correction fail

Posted: 26 Dec 2017, 21:51
by Wooze
I would like to suggest the following on this subject.
Wouldn't it be possible to use the internal temperature from an existing internal temperature sensor of a netatmo weather station as the actual temperature for the valves?
I think an external temperature sensor further away from the radiator would make it much more accurate to measure the room temperature.

Re: New app (warm)temperature correction fail

Posted: 27 Dec 2017, 20:23
by 2Qt2beStr8
+1

Re: New app (warm)temperature correction fail

Posted: 14 Jan 2018, 15:56
by Fragiolo
I tried to setup the valves thermometer as shown on the netatmo weather station value, but it doesn’t follow accurately the sensor.. so it would be a good Idea sync the valve room sensor with the weather station sensor where provided in the room.