Open Window detection

vojta66
Posts: 267
Joined: 21 Jan 2016, 11:56

Re: Open Window detection

Post by vojta66 » 26 Mar 2019, 19:50

I have seen open window symbol on my valve today! And I am quite impressed, it worked well...open window, within 2-3 minutes symbol of OWD - heating stopped - and after closing window, within 2 mins symbol off and heating again....wel done, I must say....keep it going Netatmo....
1Welcome(v409), 9 tags (v57), 1Smart Smoke (v108), 1Smart Siren (v105)
1 Weather Station(v140), Outdoor module (v46),Rain Gauge(v8), Wind Gauge(v19),4 Indoor Modules (v44)
1Thermostat(v71+relay 1st gen(v203) + 5Valves (v79)
2Presence cameras(v155)

Simon_the_Fin
Posts: 8
Joined: 07 Jan 2019, 17:26

Re: Open Window detection

Post by Simon_the_Fin » 20 Apr 2019, 09:04

Don't know if it's Open Window detection or the FW79 or problem with the valve, but one of the valves "leaked" and did not show any activity on the graph. I had opted in the beta but with this problem I disabled the OW. Last night I set the valve to frost guard, default time for that is set to 10 minutes but the frost guard was set to till morning. Tried to change the batteries and calibrated the valve. This morning the valve was leaking again. So after all this I tried to set the True Temperature this morning and right now the valve is not leaking after an hour from setting the TT.
Last edited by Simon_the_Fin on 20 Apr 2019, 09:08, edited 1 time in total.

Simon_the_Fin
Posts: 8
Joined: 07 Jan 2019, 17:26

Re: Open Window detection

Post by Simon_the_Fin » 20 Apr 2019, 09:07

From what I can remember from last night is that after calibrating the valve the valve opened a little bit, still not showing any heating in the graph. Temperature was set to 20°C and the room temperature was 22°C.

Post Reply

Return to “General questions”