Exclamation mark on valve

Post Reply
pawelf1
Posts: 10
Joined: 16 Nov 2018, 08:22

Exclamation mark on valve

Post by pawelf1 » 26 Nov 2018, 17:51

I just installed new valve it works correctly but there is a exclamation mark right to the temperature. There is no calibration error why it shows that mark?

vojta66
Posts: 306
Joined: 21 Jan 2016, 11:56
Contact:

Re: Exclamation mark on valve

Post by vojta66 » 27 Nov 2018, 22:04

Disconnected
1Welcome(v437), 9 tags (v58), 1Smart Smoke (v108),1Smart Siren (v203)
1 Weather Station(v164), Outdoor module (50),Rain Gauge(v12),Wind Gauge(v25),3 Indoor Modules (v50)
1Thermostat(v72+relay 2nd generation (v210) + 5Valves (v81)
2Presence cameras(v175)

euroben
Posts: 4
Joined: 03 Dec 2018, 15:37

Re: Exclamation mark on valve

Post by euroben » 03 Dec 2018, 16:21

Mine had that when I set them up. Just take the battery out and put it back in. It will then recalibrate itself and the exclamation mark will go away. I tried recalibrating from the app- even though it didn't say there was a calibration error but it didn't make any difference. Battery trick worked a treat.

Post Reply

Return to “General questions”