Hello,
I have just setup the Smart thermostat and now moved onto installing the smart radiator valves.
On both the valves I have installed i am getting calibration failure. I have taken off the valves and as far as I can tell are they properly on.
How do I know if I need to fit the motor caps?
Thanks
Jon
Failed calibration - Motor cap?
Re: Failed calibration - Motor cap?
topic moved to correct forum
Did you manually start the calibration?
It is normal that the valves will report „calibration failed“ after just inserting batteries without kicking off calibration manually in the settings.
Did you manually start the calibration?
It is normal that the valves will report „calibration failed“ after just inserting batteries without kicking off calibration manually in the settings.
Home: Weather Station (V3 + Rain & Wind Gauge, 3 additional Indoor Modules, Shield), Valves Starter Pack + 7 Valves, Video Doorbell
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
-
- Posts: 4
- Joined: 13 Apr 2020, 11:40
Re: Failed calibration - Motor cap?
looks like you are right, it has now cleared it self
many thanks
jon
many thanks
jon
Re: Failed calibration - Motor cap?
Home: Weather Station (V3 + Rain & Wind Gauge, 3 additional Indoor Modules, Shield), Valves Starter Pack + 7 Valves, Video Doorbell
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee