Dear all,
I have the Relay and thermostat installed quite some time ago and only recently decided to install the valves. The setup is as follows:
Relay Firmware 222
Thermostat Firmware 75
Large Bathroom Valve Firmware 85
Small Bathroom Valve Firmware 48
Kid’s Bedroom Valve Firmware 83
Large Bedroom Valve Firmware 85
Corridor Valve Firmware 48
Living Room Valve Firmware 85
Study Firmware 85
The update on the firmware seems not to be even, is there anyway the update can be "pushed" so that small bathroom valve and corridor valve get the latest updates?
I am often getting a connection error on the Corridor Valve (flashing screen and two minus signs), is that due to an issue with the firmware or is the valve defective?
Thank you!
Uneven firmware update on Valves
Uneven firmware update on Valves
Last edited by GEORGzer on 25 Jan 2021, 07:22, edited 1 time in total.
Reason: Topic moved to valve-forum
Reason: Topic moved to valve-forum
Re: Uneven firmware update on Valves
Normally they will update automatically after installation within 2-5 days.
1x Presence outdoor camera siren V3.18.0
2x Thermostat V76 + 10x Valves V100 + relais 236
1x weather station v202, outdoor module V53 and additional indoor module V53
2x Thermostat V76 + 10x Valves V100 + relais 236
1x weather station v202, outdoor module V53 and additional indoor module V53
Re: Uneven firmware update on Valves
How is the signal-strength to the valves with the oldest firmware and/or connection issues?
Home: Weather Station (V3 + Rain & Wind Gauge, 3 additional Indoor Modules, Shield), Valves Starter Pack + 7 Valves, Video Doorbell
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee