Hi all,
New user from Denmark here!
I just bought the Netatmo Smart Thermostat v2 for my heat pump. I'd love to validate my approach with the knowledgeable people of this forum, before going ahead.
The Panasonic pump offers a simple 4 pin connection for external thermostats: L/N/Cool/Heat. The below is a dump from the installation manual: https://www.panasonicproclub.com/upload ... 0(002).pdf - I've added comments and how I intend to wire up the Relais. Does this seem about right?
I may have other options for powering the Relais, once I open up the pump as well. But BLACK/GREY wires need to be applied across L/HEAT, n'est pas?
Appreciate any pointers or corrections, thanks.
Connect: Panasonic WH-MXC12J9E8 T-CAP Heatpump
Re: Connect: Panasonic WH-MXC12J9E8 T-CAP Heatpump
That should be correct, yes.
I would connect the power-cables of the Relais like that since you have dedicated terminals that provide L and N.
I would connect the power-cables of the Relais like that since you have dedicated terminals that provide L and N.
Home: Weather Station (V3 + Rain & Wind Gauge, 3 additional Indoor Modules, Shield), Valves Starter Pack + 7 Valves, Video Doorbell
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Re: Connect: Panasonic WH-MXC12J9E8 T-CAP Heatpump
Thanks so much!
Re: Connect: Panasonic WH-MXC12J9E8 T-CAP Heatpump
Home: Weather Station (V3 + Rain & Wind Gauge, 3 additional Indoor Modules, Shield), Valves Starter Pack + 7 Valves, Video Doorbell
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee
Office: Thermostat (V2), Healthy Home Coach, Smoke Alarm, 2 2in1 Sensors
Not a Netatmo employee